Milling cutter Quick 2 PRO - 20,000 rpm.

Emmi-Quick II pro - for quick removal of gel or acrylic.

The Emmi-Quick II is the ideal tool to simplify your nail modeling work. This electric nail drill quickly and thoroughly removes both coarse and fine filing work from the nail. Thanks to our selection of different bits, it is also perfectly suited for removing calluses and cuticles. The chrome-plated handpiece and simple quick-release system make the Quick II easy to use and very user-friendly.

The nail drill can be used for both manicures and pedicures. Drill bits are included.

✔ 20,000 revolutions
✔ for removing gel or acrylic nail enhancements
✔ Fast and easy bit change
✔ Forward and reverse
✔ Very low-vibration aluminum handpiece
✔ Includes 4 milling bits (for gel and cuticle removal)

➠ User manual

Technical data:

• Handle size: 135mm, Ø25mm
• Control unit dimensions: 125 x 140 x 80 mm
• Speed: max. 20,000 rpm
• Wattage: 35 watts
• Quick-release system for fast bit changes
• Power supply: 230V / 50Hz

The following items are included in the delivery in addition to the milling cutter:

• handpiece
• Flexible connection cable
• 4 milling cutter bits

Changing a bit on a milling cutter

1. Disconnect the device from the power supply
   Unplug the power cord or remove the battery.
2. quick-release fastener twist
   Turn the handpiece clockwise at the quick-release fastener. (exceed the noticeable resistance)
3. Pull out the old bit
   Carefully pull out of the collet.
4. Insert new bit
   Insert to approximately 2-4mm before the stop (not quite to the stop).
5. Tighten quick-release fastener
   Turn the handpiece counterclockwise at the quick-release fastener.
6. Check seat
   Check that it is securely fastened.

⚠️ Only then should you reconnect the device and perform a short test run.

WEEE Reg. No. DE65313320